Muskoka MFB28-2 Service Manual download pdf (Page 3)

Operation

Electric Fireplace Manual Control

The manual controls for the unit are located in the top, right

corner, on the front of the rebox (Figure 1). A switch is in

the On position when the side with the “ I ”, or “ II ” markings

on it is pushed in.

This three (3) position switch offers the following functions:

(I) Manual mode

When in the “ I ” position, the replace bypasses the built-

in remote control, the ame effect is turned on and the

electrical supply to the heater is controlled manually using

the Low Heat and High Heat Switches (Figure 1-C and D).

(II) Remote mode

The “ II ” position is for operating the unit with the provided

remote control. When in “ II ” position the unit is operated

with the ON and OFF buttons of the remote control.

NOTE: Remote control operates main power supply. Heat

must still be controlled by switches on replace.

(O) Off position

All power to all functions are switched off.

Resetting the Temperature Cutoff Switch

Should the replace overheat, an automatic cut out will turn

the heater off and it will not come back on without being

reset. It can be reset by switching the Main Power Switch

(Figure 1-A or B) to the Off (“ O ”) position, and waiting ve

(5) minutes before switching the unit back on.

CAUTION: If you need to continuously reset the heater,

unplug the unit and call Dimplex North America Limited at

1-888-346-7539 for technical support.

Remote Controls

The following plug-in remote control (Figure 2) is included

with the models and MOD levels specied below:

Used in:

DFI2309 MODs ~ to B•

DFI2310 MOD ~•

Figure 1

BCD CD

Heat Switches (all models, all MOD levels)

Figure 1-C - Low Heat Switch (“ I ”)

The Low Heat On/Off Switch supplies power to the heater fan

and the heater element. When the switch is in the On (“ I ”)

position the heater operates on Low.

Figure 1-D - High Heat Switch (“ II ”)

The High Heat Switch supplies power to the heater fan and

the heater element, when the switch is in the On (“ II ”)

position the heater operates on High. The C - Low Heat

Switch must also be in the On position for the high heat

setting to operate.

NOTE: If Switches C and D are in the Off position, only

the ame effect will turn on when the power switch is

activated.

Main Power Switches (Figure 1-A & B)

A - On/Off Switch

Used in:

DFI2309 MODs ~ to B•

DFI2310 MOD ~•

The two (2) position On/Off Switch supplies power to all the

replace functions.

B - On/Off/On Switch

Used in:

DFI2309 MODs C to D•

DFI2310 MODs A to D•

Figure 2

OPEN

Receiver outlet

Battery

cover

Plug-in

receiver

On button

Off button

Frequency

1 2 3 4 5 6 7 8 ... 18 19

Comments to this Manuals

No comments

Muskoka MFB28-2 Service Manual Page 3

Comments to this Manuals

Related products and manuals for Fireplaces Muskoka MFB28-2