Muskoka MFB28-2 Service Manual download pdf (Page 19)

7. Either pinch the clasp to release or cut each of the four

(4) mounting studs (one in each corner of the Log Driver

Board) that attach the circuit board to the chassis of the

rebox.

NOTE: If mounting studs are cut, ensure they are

replaced by those supplied with replacement board.

8. Clear both ends of mounting studs if cut.

9. Install replacement mounting studs (if necessary) by

pushing them through the sheet metal from the outside of

the rebox.

10. Properly orientate replacement Log Driver Board and

push onto mounting studs until all four (4) snap closed.

10. Remove one wire terminal from original Log Driver Board

and install onto replacement Log Driver Board, matching

its original position.

11. Continue with remaining wire connections, moving one

wire at a time, matching its original position.

WARNING: Improper re-connection of wiring may result

in electric shock, re, or injury to persons. Ensure that

connections to/from circuit board match those of the

respective wiring diagram for the particular model and

MOD level being serviced (pages 7-10).

12. Once all connections are made, follow steps 1 and 2 in

reverse order to reassemble the rebox.

Figure 21

Log Driver

Board

1 ... 18 19

No comments

Muskoka MFB28-2 Service Manual Page 19